Compliance West MegaPulse 1.2x50-12.3P-1 500 Ohm Surge Tester, EN62052-11

MegaPulse 1.2x50-12.3P-1 500 ohm, EN 62052-11 Para. 7.3.2, 12.3kV 500 ohms.

This tester is built to the requirements of IEC 60060-1 with a 500 ohm impedance. For Standards such as EN 62052-11, Clause 7.3.2 and VDE PM323E, this tester allows impulse testing to determine spacings in lieu of other requirements. This tester can perform to test parameters requiring surge voltages of up to 12kV. The MegaPulse 1.2x50-12.3 500 ohm is built specifically to conduct these tests. It uses our proprietary High Voltage relay, built to the requirements of IEC 65 Figure 7 b for robustness and complete compliance with the requirements.

In addition, for automated testing, the MegaPulse 1.2x50-12.3 500 ohm is available with TestMinder P, our computer control and test reporting option.

The MegaPulse is used with a general purpose oscilloscope for waveform capture and evaluation. Please see waveforms in Manuals section, below.

The standard configuration outputs 12.3kV at 0.5J. Can optionally be configured with three additional 0.5J voltage points at 1500, 6000 and 8000 volts.

The MegaPulse 1.2×50-12.3 500 ohm is designed to test Electricity Metering Equipment in accordance with EN 62052-11, Clause 7.3.2 at up to 12kV.

• Output: 1.2 uSec rise time and 50 uSec fall time as specified in IEC 60060-1, clause 19 “Standard Lightning Impulse”.
• Voltage Rise Time: +/- 30%
• Voltage Fall Time: +/- 20%
• Source Impedance : 500ohm +/- 10%
• Source Energy : 0.5 J +/- 10% (note: achieved at 1500V)
• Mode of Operation : Manual; Automatic and pulse train management with TestMinder option
• Charge Time : <3 sec

• Compliance West MegaPulse 1.2×50-12.3 500 ohm Datasheet.pdf
• Comliance West Megapulse 1.2×50-12.3 User Manual.pdf