Torrey Pines Scientific HP61 Fully Programmable Digital Hot Plates and Stirring Hot Plates, 12" Top

EchoTherm™ Fully Programmable Digital Hot Plates and Digital Stirring Hot Plates are the most advanced and easy-to-use units available. In manual operation, simply select the parameter to be set and enter the value needed. The unit will do the rest. In the programmable mode, routines can be stored for instant recall and use. The stored routine will run automatically, without attention, and exactly the same time after time.

Programs can be simple or complex depending upon the need. Multiple temperatures, temperature ramp rates, stirring speeds and timed events can be stored. When run, the unit monitors the program to be sure it runs exactly as written. Complete walk-away automation

• 10-program memory stored in CMOS. No batteries required
• Each program can be 10 steps, where each step includes a temperature, stirring speed, time and heating rate
• Repeat any program 1–98 times automatically. Infinite repeats settable
• Programmable and non-programmable operation
• Platinum RTD temperature measurement for ±1% accuracy
• Solid ceramic heater top for quick heating on a flat, white, chemically resistant surface
• Milled-flat cast aluminum top available for use with solids on the plate surface (‘A’ versions)
• Temperature ramping for exact heating and cooling rates
• PID temperature control to 1°C on plate surface or solution with accessory probe
• Stir aqueous solutions from 100–1500 rpm
• Timer goes up to 99 hours, 59 minutes, 59 seconds with user settable Auto-Off
• Electronic calibration stored in CMOS
• RS232 interface for control or recording data on a computer
• Custom display of all parameters all the time
• 12-month warranty
• UL, CSA and CE compliant
• Includes 10 inch stainless immersion probe

Programming:

• Memory capacity: 10 programs
• Individual Program Capacity: 10 steps
• Repeat a program automatically: 1 to 98 times or infinitely

Temperature Measurement:

• Platinum RTD: 100 ohm at zero in plate and in probe
• Range: 0–450°C on ceramic plate; 0–400°C on aluminum plate
• Readability: 1°C

Hot Plate:

• Dimensions: 12” (30.5 cm)
• Maximum plate temperature Ceramic: 450°C
• Aluminum: 400°C
• Temperature control type PID
• Temperature accuracy 1% ± of reading
• Temp stability 1°C
• Heater power in watts 1400 watt

Stirrer:

• Speed range unloaded 100–1500 rpm
• Readability 10 rpm
• Settability nearest 10 rpm

Electrical:

• Available in: 100, 115 and 230 VAC, 50/60 Hz
• Fused: yes
• Line cord: Detachable, 6 foot (1.8 meter), three-wire grounded

Dimensions:

• 12”(305 mm) x 12″ (305 mm) Top
• Width: 12.5” (31.75 cm)
• Depth: 16.0” (40.64 cm)
• Height: 9.0” (22.86 cm)

• Torrey Pines Scientific HP61 and HS61 Datasheet