Compliance West HT-4200S AC/DC Hipot Tester/Ground Continuity, 3000VAC/ 4200VDC

The Compliance West HT-4200S AC/DC Hipot Tester, UL Listed HT-S series hipot now comes with an adjustable ground continuity test in range of 0.08 - 1.50 Ω, and Auto-offset for test leads up to 1.00 Ω. Performs 0-3000 AC or 0-4200 DC Hipot Test. Neutral/Hot to Ground Leakage current test up to 10 mA AC or 5 mA DC. Easy to use and connect. Ships complete with cables, manual, and a Calibration Certificate. Made in the USA.

The continuity test/dielectric withstand test is a production line test which is recognized by safety agencies worldwide as a valid criterion of safe assembly of end-use equipment. The test ensures that the primary circuit power and ground conductors were properly wired and connected for safe operation. It also applies a high-voltage potential between power and ground conductors to make sure that no unintentional leakage or arcing paths exist between power and ground. The test consists of a ground continuity check, a leakage current check and a high voltage check. It is non-destructive to the equipment under test, and can be accomplished in a short time.

NOTE: This product does not have a NEMA (15A) plug on the front panel. It is equipped with a high voltage lead and alligator clip only. Capable of very high voltage (4200V dc). This product is not intended for regular production line testing; please refer to our HT-2000S, HT-2800S and HT-3000S testers, which are equipped with a NEMA plug for simplified production line testing.

• High precision leakage current, duration and ground continuity settings.
• Allows no load setup of leakage current and test dwell times.
• Once entered, ground continuity setting, leakage current and test dwell times can be referenced on the front panel display when unit is not testing.
• Leakage currents can be set from 1-20 mA AC or 1-5 mA DC in 0.1mA increments.
• Dwell times can be set from 1-60 seconds in 1 second increments.
• Two tests with one setup. Conducts UL/CSA Ground continuity and Hipot tests with one setup, so no additional equipment is needed.
• Small and light. 9.25″ wide x 4.75″ high x 10″ deep. 11 lbs. But rugged enough to test manufactured housing.
• Ground continuity check is defeatable for testing two-wire products.
• Simple test outcome judgement. Green lights mean pass – red lights mean fail. Failing tests sound a buzzer as well.
• Ready for your UL Inspector out of the box. NIST Traceable Calibration Certificate to MIL-STD45662-A is included. Cal cert is in accordance with UL guidance.
• Operation Instructions are printed on the rear panel for easy reference.
• In-depth testing. Both true Arc Dectection and Leakage Current circuits test the product to find problems.
• RED lights and a buzzer leave no question if a failure has occurred.
• Expandable for TUV/European Agency Testing. Can be connected to our GF-30ac 25A Ground Bond Tester with optional TEST-LINK™.
• Easy shift-by-shift Function Test. Compatible with our Patented function checker, the HTT-1and HTT-1R (With 0.1 ohm Ground check Pass/Fail Setup)

• Compliance West HT-S Datasheet.pdf